April 28th 2023
2.03.10_2.02.34 replaces 2.03.08_2.02.32
Changelog:
31.01.2023
STM: Version 2.02.34 /GD: Version 2.03.10: * bug with ASC and mA Output fixed.
* Customer wish to implement holding Temperature during Peakhold within EAAA and ASC=1
17.01.2023
STM: Version 2.02.33 /GD: Version 2.03.09: * added new command "ASC": ASC=1 enable attenuation special treatment;
ASC=0 (default) disable, normal attenuation handling.
* improvement of (Peakhold-) timing during EAAA
06.01.2023
Version 2.03.08: * Video stream issues fixed
06.12.2022
STM: Version 2.02.32 /GD: Version 2.03.07: * add new command "ICAL": set P(1-6) ,Ty (measured Temp 1),Tx (target Temp 1),Ty (measured Temp 2),Tx (target Temp 2) ….
set up to 6 calibration points (ICAL=n T11 T12 T21 T22 ...T61 T62), ?ICAL
* add new command "SIC=1/0" enable (1) 6-point calibration or standard measurement (disable, 0).
14.11.2022
Version 2.03.06: * Video freeze issue fixed.
Example:
Sensor features and updates will be applicable to all ages of sensor, the 2.03.08 offers no advantage to 2.02.32.
Firmware revisions covered by the single file starting 2.02.. are applicable to sensors built up until the end of Q3 2022 (approximately), and 2.03... thereafter. This is due to a hardware change (microcontroller) in the sensor.
*********Special Note**********
DTMD version 6.1.99 is mandatory to perform the update. You may initially have an error message that the update was not successful. If this happens, please try again after power cycling the sensor.